ep

January 28, 2021

Constant Sleeve Series
Characteristics
Straightforward and cheap all steel form of gear coupling constructed using a single sleeve and two hubs
Comparatively very simple set up
Precision lower 20° stress angle gear teeth with minimum backlash
Most common configurations are available as stock products
Angular misalignment of 1/2° per gear mesh (flex-plane)
Sizes 7/8 by way of 12, to accommodate bore sizes as much as and such as 12.50 inches
Interference match (common) and Clearance match on bores are available
Load Capacities vary from two,500 in-lbs up to two,520,000 in-lbs
Designs for applications requiring horizontal and vertical orientation, full-flex, flex-rigid, mill-motor, disengagement, sliding hubs, Shear Pin, floating shaft, and spacers
Patented and tested BUNA N seal design with reinforced washers bonded towards the inside edges which positively retain lubricant and seal the interior from outdoors contaminants
Reinforced rubber seals with snap rings to hold in lubricant
Two snap rings made of hardened spring steel which securely hold the coupling together, are simple to install or get rid of, nonetheless withstand one hundred,000 lbs of end thrust
Inch and Metric bore sizes accessible
Flanged Sleeve Series
Features
Patented tooth type for prolonged coupling daily life
Precision minimize 20° strain angle gear teeth with minimal backlash
All steel sleeves and hubs (stainless steel obtainable)
Types for applications requiring horizontal and vertical orientation
Most regular configurations are available as stock things
Angular misalignment of 1-1/2° per gear mesh (flex-plane) as much as dimension five.five, 3/4° for sizes 6 and above
Coupling sizes obtainable through dimension thirty to accommodate bore sizes up to and which include 44 inches
Interference match (standard) and Clearance fit on bores can be found
Load capacities vary from seven,600 in-lbs up to 47,269,000 in-lbs
Exposed bolts conventional on all sizes, shrouded obtainable by request up to dimension six
Conventional bolts provided are handled to be corrosion resistant
Flanged sleeve couplings are interchangeable with sector specifications
Piloted gear match for higher speeds and less vibration
Labyrinth all steel seal design and style in FL series
Inch and Metric bore sizes out there
Normal Kinds and Sizes
Sier-Bath couplings are stocked in an assortment of configurations which include C and F normal hubs and sleeves, Mill Motor hubs, Vertical design, Floating Shaft, and Spacer models. ’s excellent engineering staff make it achievable to help quite a few extra coupling kinds this kind of as the Brakedrum sort, Sliding Hub variety, Shear Pin sort, Jordan style, and custom lengths for non standard shaft separations. Additional size ranges and types to meet uncommon application prerequisites also can be produced by to meet market place demands. Material can range from regular steel to alloy steel and even stainless steel. The outstanding simplicity with the coupling layout make this all achievable.
Misalignment and End-Float Capability
The basic principle of Sier-Bath C and F type couplings is much like that of other typical flexible gear couplings. Although it’s desirable to align shafts as accurately as is possible, the purpose of any versatile coupling will be to absorb probable angular, parallel, and axial (end-float) misalignment. Sier-Bath couplings make use of a exclusive gear tooth geometry developed especially to resolve issues with shaft misalignment and accommodate from 1/2° to 1-1/2° per gear mesh or flex plane. The hub teeth are entirely crowned to supply to get a more substantial contact area and reduce stresses under misaligned problems. The crowned tooth style also eliminates nearly all of the finish loading that happens on straight gear teeth beneath misalignment.