ep

January 20, 2021

Power UNITS FOR LIFT TABLE 1
Basic Description
This energy unit is intended exclusively for the smaller lift table,Consisting of large stress gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This electrical power unit has been broadly employed inside the market of logistic gadgets including minifork lift, scissors lift and ariel working platforms. The lower-ing movement is controlled through the solenoid valve with the speed managed by the adjustable needle valve.
Energy UNITS FOR LIFT TABLE 2
Basic Description
This power unit is built solely for your medium lift table, Consisting of extremely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve along with the velocity controlled from the adjustable needle valve. When the lift rises to a high positoin, however the electrical power supply is lower, the lowering motion is controlled from the guide override function.
Energy UNITS FOR LIFT TABLE 3
Basic Description
This energy unit is built solely for that significant lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived from the solenoid valve as well as velocity controlled by a stress compensated flow management valve.
Power UNITS FOR LIFT TABLE four
Standard Description
This power unit is created exclusively to the massive lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived from the solenoid valve and also the pace controlled from the adjustable needle valve. When the lift rises to a large positoin, but the energy provide is lower, the lowering motion is controlled through the guide override perform.
Distinctive Notes
one. This energy unit is of S3 duty cycle, which could only work intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean each of the hydraulic components concerned ahead of installation of the energy unit.
three. Viscosity from the oil shoud be 15~46 cst,which need to also be clean and free of charge of impurities.N46 hydraulic oil is advised.
four. Oil shifting is needed soon after the original a hundred operation hours,afterwards after every 3000 hours.
5. The energy unit proven is built to be mounted vertically.