ep

January 18, 2021

DUMP TRAILER Power UNIT-DOUBLE ACTING
Basic Description
This electrical power unit has a electrical power up power down circuit with load holding on the two A & B ports. A strain compensatred flow control may be added to circuit to regulate the decent pace with the cylinder.
Unique Notes
one. This electrical power unit is of S3 duty cycle, i.e., non-continuous operation, thirty seconds on and 270 seconds off.
two. Clean all the hydraulic components concerned ahead of set up of the electrical power unit.
3. Viscosity of the hydraulic oil shoud be 15~46 cst, which need to also be clean and no cost of impurities. N46 hydraulic oil is suggested.
four. The electrical power unit need to be mounted horizontally.
five. Check the oil level inside the tank right after the preliminary operating from the power unit.
6. Oil transforming is required after the preliminary one hundred operation hrs, afterwards as soon as just about every 3000 hours.

DUMP TRAILER Electrical power UNIT- SINGLE ACTING
Basic Description
This power unit features a electrical power up gravity down circuit. Begin the motor to extend the cylinder and activate the solenoid valve to retract the circuit. Guide override to solenoid valve is usually supplied if essential. Also a pressure compen sated flow handle is usually extra for the circuit to control the descent pace from the cylinder.
Remark: Please seek the advice of our income engineer for your diverse pump displacement, motor energy or tank capability.
Exclusive Notes
1. This energy unit is of S3 duty cycle, i.e., non-continuous operation, 30 seconds on and 270 seconds off.
two. Clean every one of the hydraulic components concerned prior to set up of the power unit.
three. Viscosity of your hydraulic oil shoud be 15~46 cst,which must also be clean and totally free of impurities.N46 hydraulic oil is proposed.
four. The energy unit need to be mounted horizontally.
5. Check the oil level in the tank soon after the original working with the electrical power unit.
6. Oil modifying is needed after the preliminary one hundred operation hrs, afterwards after just about every 3000 hrs.